Panasonic KX-TGP600

Introduction

This page contains the settings for the Panasonic KX-TGP600. Click here for the KX-TGP500 settings. Depending on the firmware, some settings might be located in a different place or page.

Setting up the VoIP account

To access the web interface of the base station, you first need to check the IP address of the base station and enable the web interface. You do this via the handset with the following steps:

Connect your device to the same network as your computer.
Open the menu of your device and go to System Settings -> Status -> IPv4 Settings -> IP Address. Here you will see the IP address of the device.
Enable the web interface on the device. You can do this in the menu under Handset Settings -> Other Options -> Web Interface -> ON.
Log in to the web interface of the phone by entering the IP address in the address bar of your browser.

Username: admin
Password: adminpass

🌍

Specifically for our customers in the Netherlands If you have a KPN device, you need to 'empty' it, otherwise the KPN settings will be loaded and the existing settings will be overwritten when you restart the base station. Click here to follow those steps.

Go to SIP Settings
Set 'Enable Rport' to 'Yes'
Click on Save

Go to - Line 1 in the SIP Settings
Enter sip.voys.co.za in the following fields:

Registrar Server Address
Proxy Server Address
Presence Server Address
Outbound Proxy Server Address
Service Domain

Enter the 'Account ID' in the following fields:

Phone Number
Authentication ID

Set 'Enable DNS SRV lookup' to 'Yes'

Click on Save

Go to VoIP Settings - Line 1
For PCMA, set 'Enable' to 'Yes' with 'Priority' 1
For G.729A, set 'Enable' to 'Yes' with 'Priority' 2
For PCMU, set 'Enable' to 'No'
Set 'DTMF Type' to 'RFC2833'
Click on Save

FAQ

‣

Why does my Panasonic stay on ‘initializing’?

Panasonic KX-TGP500

My Panasonic was used to be setup by KPN

Panasonic